Hum 500x Wireless Headphone Instructions
Functions:
- Power On
- Hold down Center button for 4 seconds.
- LED will flash BLUE and then Flash Red/Blue while in pairing mode.
- Power Off
- Hold down Center button for 5 seconds.
- LED will flash RED and then headphone will turn off.
- Headphone will automatically turn off after 10 minutes in pairing mode.
Charging
- When headphone is powered off and charging, LED with be a solid RED.
- When headphone is powered off and is fully charged, LED will shut off.
- When headphone is powered on and charging, LED will be a solid RED.
- When headphone is powered on and fully charged, LED will shut off.
LEDs
| Flashing Blue | Power On / Paired to Device |
| Flashing Red/Blue | Pairing Mode |
| Flashing Red | Low Battery |
| Flashing Red then Off | Powering Off |
| Solid Red | Charging |
| No LEDs | Off / Finished Charging |
Functions
| Button | Function |
| Short Press (O) | Pause / Play / Answer / Hang up |
| 3 Second Press (O) | Voice Assist |
| 4+ Second Press (O) | Power On / Off |
| Short Press (-) | Previous Track |
| Long Press (-) | Volume Decrease |
| Short Press (+) | Forward Track |
| Long Press (+) | Volume Increase |
Connecting to the App
The Hum 500x can connect to the Wicked Audio App. To learn more, go to go.wickedaudio.com/app
PRECAUTIONS
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.
Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.
SAFE USE & HAZARD WARNINGS
- 90 dB SPL at 8 hours
- 95 dB SPL at 4 hours
- 100 dB SPL at 2 hours
- 105 dB SPL at 1 hours
- 110 dB SPL at 30 min.
- 115 dB SPL at 15 min.
- 120 dB SPL Avoid as damage may occur
IMPORTANT SAFETY INSTRUCTION
- Read these instructions.
- Keep these instructions.
- Heed all warnings
- Follow all instructions.
Attention should be drawn to the environmental aspects of battery disposal; The use of apparatus in moderate climates.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
LIMITATION OF LIABILITY Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. In no event, under any cause of action of theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential, special, exemplary or punitive damages, of any and all nature whatsoever, arising out of use of or inability to use a product.
This includes without limitation, property damage, loss of value of the product or any third party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages that one may encounter. Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics devices or other personal property that are contained in inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held devices, or any loss of data contained on the foreign device. Notwithstanding any damages that you might incur for general damages in contract, tort (including negligence) or otherwise), the entire aggregate liability of Wicked Audio and any of its distributors and/or suppliers shall be limited to the amount actually paid by you for the Wicked Audio product giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.
- MODEL #: WI-BTAPP500
- IC: 20526-WIBTAPP50X
- FCC: 2AFM7WI-BTAPP50X
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- -Reorient or relocate the receiving antenna.
- -Increase the separation between the equipment and receiver.
- -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- -Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction
Model numbers associated with this product:
WI-BTAPP500, WI-BTAPP50X, WI-BTAPP501, Hum500x, Hum 500 x, Hum 500x, HUM500